Within Canada, comfort levels with the oil and gas industry vary widely by region, but even in Western Canada, where shale gas development has proceeded under the umbrella of existing regulations, changes may be needed to encompass ways in which hydraulic fracturing is different from conventional drilling.
WHAT IS FRACKING?
Hydraulic fracturing, or fracking, is a way of liberating reserves of natural gas that are locked within shale formations deep below the surface. Because shale is not very porous, gas does not travel through the rock easily. Unlike conventional gas wells, merely drilling down is not enough to get the shale gas out.
A shale gas well begins vertically but then bends once it reaches the shale layer and continues horizontally to maximize access to the gas-bearing rock.
After the drilling, a series of explosive charges followed by the injection of a fluid under high pressure is used to fracture the rock. This opens up cracks in the rock. Sand grains in the fluid get into the cracks and keep them open, allowing the gas to seep into the well and travel up to the surface.
WHAT'S IN THE FRACKING FLUID?
Most of the fluid injected into shale gas wells is simply water and fine particles of sand or clay, but an array of chemical additives are used to improve fluid flow and inhibit the buildup of minerals and bacteria. The precise mix may vary from well to well depending on geology and other factors. British Columbia and Alberta require operators to disclose the chemicals they use, although there is some leeway in the rules to allow for protection of trade secrets.
WHAT ARE THE CONCERNS?
A new report from the Council of Canadian Academies looks closely at what is known about the possible environmental impacts of shale gas extraction in Canada. Although the technology is evolving rapidly and data is gradually emerging from the United States where the industry has expanded rapidly, the report finds a number of areas where uncertainties remain.
Improperly formed or deteriorating cement around the upper sections of a well bore can allow gas to leak and potentially reach groundwater. Well integrity is a persistent challenge in the gas industry but the risk of poor well construction is amplified when it comes to hydraulic fracturing because of the pressures and wear and tear associated with the process and because many more wells are needed per unit of gas extracted relative to conventional drilling.
Gas leaks and climate change
Natural gas burns more cleanly than coal and puts less carbon in the atmosphere. It has been touted as a bridge to a low carbon energy future and a way to help slow the warming of the Earth’s climate. However, methane, the primary constituent in natural gas is also a greenhouse gas. Research is currently divided over how much methane is leaking from shale gas operations and to what extent those leaks reduce the potential benefits of natural gas for climate change.
Industrial activity and pollution
The industrial activity associated with hydraulic fracturing can have bigger and more obvious impacts on the environment than the process itself. A large increase in emissions related to high truck traffic, drilling rig operations, gas compressors and other industrial effects generates air pollution, noise and other social impacts in areas that are not accustomed to resource extraction.
Some of the fluid used in hydraulic fracturing returns to the surface and must be disposed of. This flowback water carries material from deep below that may pose a health risk, from radioactive minerals to compounds such as benzene that are associated with gas deposits. In regions where reinjection into the ground is not an option, the holding, shipping and disposal of large quantities of flowback water has the potential to create a significant environmental hazard.
Both hydraulic fracturing and wastewater reinjection have been known to trigger minor earthquakes. The threat of harm from such events is generally considered to be low but seismic events can be minimized with more detailed information on geological conditions in areas where shale gas extraction is proposed.
HOW MUCH SHALE GAS DOES CANADA HAVE?
Estimates suggest there could be more than 3,000 trillion cubic feet of shale gas in Canada -- more than 50 times the country’s remaining conventional gas reserves. However, current techniques are typically not able to recover more than about 30 per cent of the gas in shale formations.
Discover content from The Globe and Mail that you might otherwise not have come across. Here we’ll provide you with fresh suggestions where we will continue to make even better ones as we get to know you better.
You can let us know if a suggestion is not to your liking by hitting the ‘’ close button to the right of the headline.